Woodworking engraving machine without suction solution

In the use of woodworking engraving machine, there may be a phenomenon that the suction table has no suction and cannot absorb the plate. What is the cause of this problem? How should we solve it? Today, Shandong engraving machine manufacturer introduces the woodworking engraving machine table to you. Solution:
1. Is the motor line voltage normal?
2. Whether the water circulation air pump adds less water, whether the motor is stuck or not, and the rotating shaft of the motor fan protection net is removed;
3. The filter in the vacuum pump is blocked and cleaned;
4. The surface of the counter or pipe is trimmed by air leakage;
5, forward and reverse exchange motor, any two lines change the direction of the motor.
The woodworking engraving machine uses vacuum adsorption to fix the plate, which can not only be firmly fixed, but also does not move and engrave the misalignment, etc., and the plate is fixed relative to the splint, which can save the plate and engrave to the edge of the plate. In order to better use the woodworking engraving machine, Shandong The engraving machine manufacturer reminds you that you need to solve the problem of no suction in time.